Service area
Where we work, and what the concrete does there
This is not a list of places we will drive to. A Wasaga Beach slab on sand with a high water table and a Clearview implement shed poured in 1974 are not the same job, and quoting them the same way is how coatings fail.
Each page below sets out what we actually find in that community — the age and construction of the slabs, how much salt they see, and which of them we expect the moisture test to catch.
-
Collingwood
Collingwood splits cleanly into slabs poured in the last decade and slabs poured before anyone put a vapour barrier under them. The job is a different job depending on which side of that line your garage sits.
-
The Blue Mountains
A chalet garage takes more abuse in one ski season than a family garage takes in five, and the only windows to work in are the weeks nobody is renting.
-
Wasaga Beach
Wasaga is the one town where we expect the moisture test to fail before we run it. Sand, a high table and a lot of slabs poured for buildings that were originally cottages.
-
Thornbury
Thornbury runs older and smaller than Collingwood, with a strong showing of detached workshops and heated outbuildings — the one context where we will genuinely recommend epoxy.
-
Stayner
Stayner and the surrounding Clearview concessions bring the largest unheated floors we work on, and the ones where cold-cure capability stops being a convenience and becomes the whole job.
-
Creemore & Clearview
Rural Clearview property means older outbuildings, slabs poured by whoever was available, and no mains water on site — which changes how we prepare a floor.
-
Meaford
The western edge of our area. Shoreline property with the moisture questions that come with it, and the apple country equipment floors that run east from here to Thornbury.
Not sure if you're in the area?
Call and ask. If you are outside what we cover we will say so rather than book you in and cancel — and we can usually point you at someone local who does cover it.